MOCET M22 User Manual
Page 25
M22 USER MANUAL
2
Headset
Connector
RJ-9 Jack for connecting headset cord.
3
LAN Port
RJ-45 Jack 100/10Mbps Ethernet port for connecting to the
local area network (LAN). This port can support power over
Ethernet (PoE) if the LAN switch provides it.
4
PC Port
RJ-45 Jack 100/10Mbps Ethernet port for connecting to a
computer.
5
Power Jack
If a power source from adaptor is required, please order the
M22 power adapter separately from MOCET.
6
EDM Port
SATA interface for attaching the Extended Dial (EDM)
accessory. Up to two EDM units can be supported on the M22.
Please refer to EDM Quick Installation Guide for more
information.
7
Console/EHS
Port
1. Console port for engineering maintaince purpose. or
2. EHS Port (Electrical Hook Switch) connects to IP-EHS for
Wireless Headset support. This can be connected to
general DHSG I/F(eg. Jabra) or APD-80 I/F of Plantronics. The
default is set to EHS. And switching between Console and EHS
will be done by software.
8
Stand Slots
These 2 slots are used for snapping the stand.
9
Hang Holes
These 2 holes are reserved for wall-mount support
10
Wire Route
Ditch
The wires of Handset and Headset can be routed and run in the
ditches.
25