MOCET IP Commander - Manual (Page 39)

Page 39 Page 39
IP Commander for iOS VoIP User Manual
7. Contacts
In IP Commander, you can maintain two different contact lists. The first contact list is a
dedicated address book used by IP Commander. This address book is belongs to IP
Commander’s own database which not shared with other iPad apps. The second
contact list is to use the standard iPad Contacts that is shared by other iPad apps.
To access the contact lists, you have to select “Contacts” command from the main menu,
then you will see three tags at the top side of sub-command area, they are “All Contacts”,
“Group”, and “Dial from iPad” (see below picture).
- All Contacts: Touching “All Contacts” tag will display all contacts that were stored in
the IP Commander’s own database.
- Group: You may classify the contacts in different groups. Selecting “Group” tag will
display all the available contact groups.
- Dial from iPad: Touching this tag will invoke iPad’s standard Contacts. You may
also make a call to a contact that is stored in the iPad’s standard Contacts.
In the following sections, you will learn how to manage the IP Commander’s Contacts
database
7.1 Add a Contact
To add a new contact into the Contact list, please follow the following steps:
1.
Select “Contacts” command from the main menu.
2. Select “All Contacts” tag from the sub-command area
3. Select “+” to add a new contact from the sub-command area
4. Select “New Contact” from the pop-up menu
5. An “Add New Contact” table is displayed for you to build a new contact
6. Please fill out the “Add New Contact” table with this contact information
7. Press “Save” to store this new contact into the IP Commander’s Contacts