MOCET IP Commander - Manual (Page 23)

Page 23 Page 23
IP Commander for iOS VoIP User Manual
1. During an active call, press the Transfer ( ) function key from IP Commander
2. When you hear the dial tone, you may call the third party from IP Commander’s soft
dial keypad
3. Wait for the third party to answer the call.
4. When the third party answered the call, just hang on your call, then the on-going call
will be transferred to the third party.
4.9 Forwarding a Call
You can configure the IP3092 Communicator to forward the incoming call to another
party.
There are four types of static forwarding:
 Unconditional
 Busy Forward
 No Answer Forward
 DND Forward
To setup the call forward, please follow the following steps:
1. Select “Settings” command from the main menu.
2. Select “Line Settings (User Level)” from the sub-command area
3. Select “Line X” (X = 1 ~ 4) from the sub-command area.
4. Select Call Forward from the sub-command area
5. The following table will be displayed to setup the call forward function and forward
number.
4.10 Blocking a Call
You can reject some specific phone numbers from the setting of Call Block. Each line
is allowed to block up to 10 specific phone numbers.
To configure the call block, please follow the following steps:
1. Select “Settings” command from the main menu.