MOCET IP Commander - Manual (Page 31)

Page 31 Page 31
IP Commander for iOS VoIP User Manual
5.3.2 DECT to Base or DECT to DECT Intercom call
Please refer to you DECT handset user manual to learn how to make an intercom
callfrom a DECT handset to base handset or another DECT handset.
5.3.3 Paging DECT Handset
Communicator DECT base provides paging function to page a registered DECT
Handset. To paging a Handset, please follow the steps described in Section 5.1 to
enter Register Mode, then turn on / off the Paging button to control the paging function.
Only a handset can be paged at one time.
5.4 SIP line Call Configuration
The mini PBX supports the following features for each SIP trunk (line):

DID (Direct Inwards Dialing) Calling: User will receive a call from SIP trunk line
directly to a specific registered handset configured with a direct inward dial (DID)
number.
 Hunting Group: In a hunting group, when the first registered handset in the
group is busy, the other handsets in the group will receive it. If no handset in the
group is available, the calling party will hear a busy signal.
 Ring Group: In a ringing group, an incoming call to the phone will cause all the
handsets to ring. When one registered handset picks up the incoming call, the
others will be released.