MOCET IP Commander - Manual (Page 19)

Page 19 Page 19
IP Commander for iOS VoIP User Manual
4. Basic Call Features
The IP Commander supports each SIP line with 2 simultaneous calls. However, only
one call can be active at one time. The active call is the one you are using to speak or
listen to. The inactive calls can be:
 On
hold
 Joined in a conference (with up to 3 callers)
 “Incoming call” or “Ringing”
This chapter describes the basic operating instructions from IP Commander.
4.1 Placing a Call
You can place a call in many ways from the IP Commander:
 Using the handset
 Using the speakerphone
 Pressing the line key from IP Commander screen
 Using the headset
 Dial the number from IP Commander’s numeric keypad
No matter which way you are using to dial the party, the dialing screen will display the
phone number or SIP URL (input from iPad’s soft keyboard) you dialed. During a call,
you can alternate between using the handset or speakerphone modes by pressing the
speakerphone key, or picking up the handset while on a speakerphone call.