2 hunting group & ring group settings – MOCET IP Commander User Manual
Page 33
Page 33
Page 33
IP Commander for iOS VoIP User Manual
Select a Handset for Line 1 DID
5.4.2 Hunting Group & Ring Group Settings
You may configure a hunting group or ringing group for a SIP line thus an incoming
call can ring several handsets at the same time or in hunting sequence, the setting
procedures of Hunting or Ring Group are the same, please follow the following steps
to do the configuration:
1. Follow the same steps1 ~ 4 in Section 5.4.1
2. Select the line you want to do Ring or Hunting Group setting
3. Select “Tap to Select” to pop up a “Select DECT Type” menu
4. Select “Ring Group” or “Hunting Group” from the pop-up menu
5. A new menu on the sub-command area for ask you to select the grouped Handsets
6. Turn on the grouped handsets for for this line
7. Press “Save” to confirm the settings