Marsh Sound Design The HT 4000 High Resolution Audio-Video Processor - Manual (Page 15)

Marsh Sound Design
15
CONTROLS
&
FUNCTIONS
Remote Control Learning MODE
The remote allows you to transfer a command from a button on your source remote control
(original equipment remote control) to a button on the remote control. New commands can be
taught to any button in the CD, DVD, AUX, SAT, TVVCR and CBL device modes, except on the LIGHT
button.
The remote control provides distinct visual feedback with LEDs (Light Emitting Diodes) that are
located at the top left of the remote control (Status LED) and under the Device buttons. The Status LED
at the top left of the remote operates in three colors (red, orange and green). The Device buttons have
a red color LED behind them. These LEDs will assist you in programming in the learning section of the
remote control.
Select a Device mode in which you would like to teach the new command, i.e. if you wanted to
learn a new command to the PRE. CH button in the TV mode on the remote, you would select the TV
Device button and then use the instructions below to teach the new command to the PRE. CH button.
. Press the Device button and the SELECT button simultaneously, and hold until the orange
Status LED and the Device button turn on and remain lit.
On the remote control, press the button that is to be taught the new command. The
orange Status LED will begin to flash continuously. The Device LED will turn off.
On the source remote control (original remote control), press and hold the button for the
command to be learned until the Status LED on the remote turns green. Release the button on the
source remote control.
Press the button on the source remote control, once again to verify that the new command
has been learned correctly. The Status LED will flash green twice and then turn to a steady orange
color indicating that the programming was successful. The Device LED will turn on
Repeat Steps 2 through 4 for any other buttons to be taught in the Device mode selected in Step 1.
Once you have completed learning new commands to buttons in the selected Device mode
you must save the programmed information. Press and hold the Device button and SELECT button
simultaneously, and hold until the orange Status LED flashes twice. The Device button will turn off
Please repeat for any other Device modes starting from Step 1.
Press the Device button and SELECT buttons simultaneously, and hold until
Learning a New Command
Step 1
Step 2.
Step 3.
Step 4.
Step 5.
To Erase a Learned Command From a Button
Step 1. the orange
Status LED and the Device button turn on and remain lit.