beautypg.com

Installing and upgrading simman 3g software, Removing or changing router, Maintenance – Laerdal SimMan 3G User Manual

Page 34: Instructor pc and patient monitor pc, Simulator firmware & network fixer

background image

34

MAINTENANCE

Installing and Upgrading

SimMan 3G Software

SimMan 3G software comes pre-installed. When updating
LLEAP, check if updates for Patient Monitor, SimDesigner and
SessionViewer/SimView are also available.

All available software must be updated at the same time. Install or
update the software in the following order:

1 Update the Software on the instructor PC. See Instructor PC and

Patient Monitor PC section.

2 Update the Software on the Patient Monitor PC. See Instructor

PC and Patient Monitor PC section.

3 Update the Software on the Patient Simulator. See Simulator

Firmware & Network Fixer section.

Instructor PC and Patient Monitor PC

1 Power on computer and ensure no SimMan 3G applications are

running.

2 DO NOT uninstall the SimMan 3G software from your

computer. Visit www.laerdal.com/downloads to download the
latest version of SimMan 3G and Laerdal Debrief Viewer. Select
SimMan 3G and press “Click to Download” then follow the
on-screen instructions to install.

3 In the installation menu – click the

Software> button once. This will start copying files to your
computer.

Note: The copying process takes approximately 2-3 minutes. Once
the copying process has finished, please follow instructions in the
installation wizard.

Note: The software will update automatically if started whilst
connected to the Internet.

Simulator Firmware & Network Fixer

The Patient Simulator software update is handled by the Simulator
Firmware & Network Fixer application. To update the Patient
Simulator software, follow the instructions in Simulator Firmware &
Network Fixer Help.

Caution: Do not switch OFF the Patient Simulator while updating
the Patient Simulator Software.

Removing or Changing Router

The router may be changed or removed. Turn off the Patient
Simulator before doing so.

Open the pelvis and locate the router. Remove the two Ethernet
cables and black power cable.

If you would like to operate the Patient Simulator without a router,
then attach a through-adapter between the two Ethernet cables.

If you would like to install a new router, attach the power cable to
the DC plug and the Ethernet cables back into the router again.