Konig Electronic Wireless rear view camera system - Manual (Page 4)

4
3. Set the transmitter switch to a channel (1, 2, 3 or 4) and check which offers the best reception. On the monitor
select the same channel by pushing the channel button until the monitor shows the picture of the camera
4. Connect the power cable (red/black) to a battery power source
5. Connect the mini plug (2.5mm) of the camera to the contra plug (2.5mm) of the cable of the transmitter
6. Camera mounted on the separate bracket (included)
Screw the small metal square plate to the gooseneck
bracket. Slide the back of the monitor over the metal
plate to attach the monitor to the gooseneck bracket
Attach the antenna to the antenna connection on the
back of the monitor
Specifications:
Monitor:
• Voltage: DC 12 V
• Consumption Current: 280 mA
• Operation Temperature: -10°C ~ +50°C
• Operation Humidity: 85% (max.)
• Display Format: 320x240
• Screen Size: 3.5” (diagonal)
• Receiving frequency: 2414 MHz, 2432 MHz, 2450M Hz, 2468 MHz
• Receiving sensitivity: -85 dBm
• Video System: PAL/NTSC
• Dimensions: 102x71x25 mm
Camera:
• Imaging Sensor: CMOS
• System: PAL (638x582)/NTSC (512x492)
• Horizontal resolution: 380 TV Lines
• View angle: 120°
• S/N Ratio: 48 dB
• Consumption Current: 200 mA
• Voltage: DC 12 V
• Working temperature: -20°C ~ +70°C
• Dimensions: ø24x38 mm
• Dust/water protection: IP44 (protect against solid items >1mm and also water splashing from all directions)
Transmitter:
• Transmitting frequency: 2414 MHz, 2432 MHz, 2450 MHz, 2468 MHz
• Transmission power: 10 mW
• Bandwidth: 18 MHz
• Voltage: DC 12 V ~ 16 V
• Unobstructed effective range: ±50 m
• Dimensions: 55x49x10 mm