Konig Electronic USB turntable - Manual (Page 30)

30
Problem Cause Solution
THE WHOLE UNIT
Power does not come on
when the unit is switched on.
Unit is unplugged.
Connect the unit to the AC
power supply.
The sound is distorted.
The unit is too close to a TV set
or another similar appliance.
Turn off the TV or other
appliance and relocate the
unit.
Specifications
DC servo motor
Belt drive
33-1/3 rpm, 45 rpm and 78 rpm
Less than 0.25% (WTD)
More than 35 dB
Ceramic stereo cartridge
402-M208-165
160-380 mV (5 cm/sec at 1 KHz)
AC 230 V ~ 50 Hz
5 W
390 x 117 x 330 mm
2.715 kg (approx.)
Instruction Manual
Audacity Software Driver CD
USB Cable
Safety precautions:
To reduce risk of electric shock, this product should ONLY be opened by an
authorized technician when service is required. Disconnect the product from
mains and other equipment if a problem should occur. Do not expose the product
to water or moisture.
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
General:
Designs and specifications are subject to change without notice.
All logos brands and product names are trademarks or registered trademarks of their respective holders and
are hereby recognized as such.
Keep this manual and packaging for future reference.
Attention:
This product is marked with this symbol. It means that used electrical and electronic products
should not be mixed with general household waste. There is a separate collections system for these
products.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION