HITEC Optic 6 Sport 2.4 - Manual (Page 15)

Page 27 Page 28
Model Setup Menu Programming for Powered Airplanes (ACRO)
ACRO Functions Map
EPA End Point Adjust (Servo travel) 27 D/R Dual Rates 27
EXP Exponential Settings 28 S-TRM Sub-Trim (Neutral Settings) 28
S-REV SERVO Reverse 29 P.MIX Programmable Mixer 29
ELVN Elevon Mixing (Tailless models) 29 FLPN Flaperon (Combined Flaps & Ailerons) 30
V-TAL V-tail Mixing 30 A->R Rudder Coupling 31
E->F Elevator Flap Mixing 32 CUT Throttle Cut (Engine Shut Off) 33
CAMB Camber (Combined Flaps & Ailerons) 34 FLT.C Flight Condition (NOR, ST1, ST2, ST3)
Gear Swich (SW-1) Controls - Receiver CH5
FLT MODE (SW-3) Switch Aft = CAMB On
Voltage/Timer Display
Normal Display Mode
End Point Adjust [EPA]
Press both Edit buttons
Dual Rate Set [D/R]
Exponetial [EXP]
Sub -Trims [S.TRM]
Servo Reversing [REV]
Programmable mix [PMIX]
Elevon Mix [ELVN]
Flaperon Mix [FLPN]
V-Tail [VTAL]
Ail->Rud Mix [A-R]
Elev->Flap Mix [E-F]
Throttle Cut [T.CUT]
Camber [CAMB]
FLT.C
To set up the Optic 6 Sport 2.4GHz to fly a particular model, you need to get into the radio's second programming menu: the model setup menu.
In this menu you can program specific control functions; set servo throw direction; and set the values of servo travel, exponential rates and
dual rates for the particular model you selected earlier in the initial setup menu.
Go ahead and switch the transmitter on-you are now in the standard operating screen.
In the upper left-hand corner it will say "ACRO" and to the right there will be a large number telling you the state of the battery voltage
(such as 7.2 v) and a smaller single-digit number indicating the model slot the radio is currently opened to.
There will also be a little black box at the bottom of the screen with the symbol "NOR". This indicates that the system is currently in the
"normal" flight condition mode. Later, we will show you how to activate the flight condition modes-and it is here on the screen where you will
be told which mode is currently active.
Now push down both EDIT buttons at the same time.
The following menu items will appear as you scroll down the list by pushing down the right-hand EDIT button:
Optic 6 Sport ACRO in-Flight Controls
This figure shows the assignments for a Mode 2 system as supplied by the factory.
Note that some of the functions will not operate until activated in the mixing menus.
When programming a model for the first time,
start with setting servo direction and then
activate any mix's needed like Flaperon,
Elevon or Aileron/Rudder.
Next, progress through adjusting subtrim and
setting end point travel of each servo; then set
exponential and dual rate values.
Trainer/Engine Cut Switch
SW 3
SW 1
Rudder &
Throttle Stick Aileron &
Elevator Stick Plastic Side Panel
SW 2
Antenna
Trim Switch
Power Switch