HITEC Optic 6 Sport 2.4 - Manual (Page 10)

Page 17 Page 18
Optima Series Receiver Features and setup Set-up and Use of the Hitec 2.4GHz System
1Sec.
3Sec.
3Sec.
Turn on transmitter, then the receiver.
After connected, make sure you have control over the model.
Then press & hold the button on the back of transmitter for 6 seconds,
you will hear one beep followed by two beeps then release the button.
Approximately one second after button released, the system will switch to Scan Mode
noted by the blue and red LED and one beep.
Switching from Normal Mode to Scan Mode
1Sec.
3Sec.
3Sec.
Turn on transmitter, then the receiver. You will hear two short beep sound for Scan Mode You will hear four short beep
sound for Normal Mode
After connected, make sure you have control over the model.
Then press & hold the button on the back of transmitter for 6 seconds,
you will hear one beep followed by two beeps then release the button.
Approximately one second after button released, the system will switch to Normal Mode
noted by the red LED and two beeps.
Switching from Scan Mode to Normal Mode