Heath Consultants Hi Flow Sampler - Manual (Page 22)

Operation Hi Flow

Sampler
22 Instruction 0055-9017
2. Highlight Manual 1-Stage, and then press the I/O ↵ key.
3. Press ESC to return to the Main Screen. Observe that (M) should appear at the
bottom of the screen.
2.15 Access Records
Note:
Send Records can only be selected if operating in the Expanded Menu Mode. Refer
to Section 2.8.
Selecting Access Records from the Expanded Menu System allows a user to either:
1) send all saved records to a personal computer,
2) view the records on the unit’s LCD screen, or
3) erase all saved records.
2.15.1 Send Records
All the measured and calculated values that were saved in memory can be downloaded
to a personal computer as comma-delimited ASCII text, which can later be imported into
most spreadsheet programs for analysis.
The following describes how to download saved records to a computer that is running
Windows ® HyperTerminal as the communications program. If a different operating
system and/or communications program is being used, then please consult the
appropriate instruction manuals for those products.
Note:
Send Records can only be selected if operating in the Expanded Menu Mode. Refer
to Section 2.8.
1. Install serial data cable P/N 104-4027 (straight through, 6 foot, DB9 male to DB9
female) between the computer’s COM port and the COMPUTER connector of the Hi
Flow
 . (For computers having a 25-pin or USB COM port, the user must supply the
appropriate adapter, or use a serial cable with appropriate connectors on each
end.)
2. On the computer, start HyperTerminal by doing one of the following:
- If HyperTerminal has already been set up to communicate with the Hi Flow 
Sampler, then select Start > Programs > Accessories > Communications >
HyperTerminal, and double-click the filename or icon that has been associated
with the instrument.
- If HyperTerminal has never been run in association with the Hi Flow  Sampler,
then a new HyperTerminal connection needs to be made as follows:
a. Select Start > Run. In the Run box type “hypertrm.exe” and click OK. The
New Connection dialog box should appear.
b. Type in a New Connection Name such as “HiFlow”. Click OK to select the
default icon (if desired, select a different icon before clicking OK). The
Connect To dialog box should appear.