With intel® core™2 duo cpu, Specifications – Hatteland Display 13 inch - HD 13T21 MMC (Widescreen, Inte Cor2 Duo CPU) User Manual
Page 36

36
IND100129-137
All specifications are subject to change without prior notice!
Specifications - HD 13T21 MMC-xxx-xxxx
With Intel® Core™2 Duo CPU
SPECIFICATIONS
Note: All specifi cations are subject to change without prior notice!
Please visit www.hatteland-display.com for the latest electronic version.
2/2
• Operating
: Temperature -15 deg. C to +55 deg. C
Humidity up to 95%
• Storage
: Temperature -20 deg. C to +60 deg. C
Humidity up to 95%
• IP-Rating
: Protection: IP66 front - IP22 rear (EN60529)
• Compass Safe Distance : Standard: 80cm - Steering: 45cm
Lifetime Considerations:
Even although the test conditions for bridge units provide for a maximum
operating temperature of 55°C, continuous operation of all electronic
components should, if possible, take place at ambient temperatures of only
25°C. This is a necessary prerequisite for long life and low service costs.
• W:355.00 [13.98''] x H:248.50 [9.78''] x D:65.35 [2.57''] mm [inch]
• 4 x M4 VESA mounting 75x75mm, Max 4mm deep
• Built-in Console mounting 4 x M5x15mm screws
• Weight: 4.8kg / 10.6lbs
This product have been tested / type approved by the following classification societies:
IEC 60945 4th (EN 60945:2002)
IACS E10
IP66
ClassNK - Nippon Kaiji Kyokai
GL - Germanischer Lloyd
DNV - Det Norske Veritas
ABS - American Bureau of Shipping
BV - Bureau Veritas
LRS - Loyd’s Register of Shipping
CCS - China Classification Society
EU RO MR - Mutual Recognition
Power Supply:
• 2 x 24VDC
: Model HD 13T21 MMC-Exx-xxxx
Dual input, galvanic isolated, automatic switch between power source
Power Consumption:
• Operating
: 35W (typ) - 60W (max)
• 13.3 inch TFT Liquid Crystal Display module, Widescreen,
• Aspect Ratio 16:10, a-si TFT Active Matrix,
• LED Backlight Technology
• Native Resolution
: 1280 x 800 (WXGA)
• Pixel Pitch (RGB)
: 0.2235 (H) x 0.2235 (V) mm
• Response Time
: 6/10ms (typical) (Tr/Tf)
• Contrast Ratio
: 800:1 (typical)
• Light Intensity
: 500 cd/m
2
(typical)
• Viewable Angle
: 70 deg (H) 60 deg (V) (typical)
• Active Display Area
: 286.08 (H) x 178.8 (V) mm
• Max Colors
: 262000
Behind front bezel - Glass Display Control™ (GDC) IP66:
• Power On/Off, Brightness Control (-/+), Light Sensor (not visible)
• Programmable Alarm LED, Buzzer (not visible)
• OS Options
: None or see table below
• CPU/Processor
: 1 x Intel® Core™2 Duo Desktop Processor P8400
2.26GHz, Bus Speed 1066MHz, 3MB L2 Cache
• Storage Options
: None or see table below
• Memory Options
: None or see table below
• System Chipset
: Intel® GM45 / ICH9
• Graphics Chipset
: Intel® Graphics Media Accelerator GMA
4500MHD Integrated/Daughter Board (CH7307C)
• BIOS
: AWARD
• Speaker
: None
• Buzzer
: Yes (according to EN60945)
• Power Manager
: ACPI
• HW Status Monitor : Temperatures, voltages & cooling fan status.
Auto throttling control if CPU overheats
• Resolution Range
: From 640 x 480 to 1280 x 800
• Sync. Range
: Hor: 24 kHz to 81 kHz, Ver: 50 Hz to 75 Hz*
• MAX OUT Resolution : As DVI: Max 1600 x 1200 @ 60Hz or via blanking
: As RGB: 1920 x 1200 @ 75 Hz
* Native 1:1 resolution recommended is 1280 x 800 @ 60 Hz.
* If resolution is set above 1:1, desktop scrolling mode will be used.
• 1 x COM RS-232/422/485 non-isolated (TBD connector)
• 1 x miniPCIe - Require modi cation of chassis
• 2 x CAN isolated module (2 x 4-pin Terminal Block 3.81, 2 channel)
• 1 x VGA ouput, for addtional / external display (15P connector)
• 4 x COM RS-422/485 isolated NMEA Compliant (5-pin Terminal Block 3.81)
• 4 x COM RS-232 non-isolated module (9P D-DSUB connectors)
• 1 x Mechanical Relay (NO/NC) (1 x 5-pin Terminal Block 3.81)
• 1 x PCA100298-1 (LAN 10/100Mbps, 2 ports (RJ45)
Note: Contact us for possible combinations
Connector
Rear
• Primary Power 24VDC
1 x 2-pin Terminal Block 5.08
• Secondary Power 24VDC
1 x 2-pin Terminal Block 5.08
• LAN
4 x RJ45
• USB2.0 (<5m)
4 x Type A
• Solid State Relay (NO)
(over current protection)
1 x 4-pin Terminal Block 3.81*
• Digital Input
(isolated/protected)
1 x 4-pin Terminal Block 3.81
• COM (isolated RS-422/485)
1 x 5-pin Terminal Block 3.81
• Safety Signal Relay (NO/NC) 1 x 5-pin Terminal Block 3.81
• DVI-I or as RGB via adapter 1 x DVI-I 29pin
A P P R O V A L S & C E R T I F I C A T E S
Input/Output Connectors:
Environmental Considerations:
Power Specifications:
Physical Dimensions:
TFT Characteristics:
TFT Technology:
User Controls:
Computer Specifications:
Capabilities / Prepared for:
• Optical Bonding Technology
• Variations of SSD Storage, RAM Memory, Operating System
Factory Mounted Options:
Type
Description
Size/Speci cation
Memory 1 x Dual Channel, 200-pin DDR2
800MHz SO-DIMM
- 1GB, 2GB, 4GB
Storage
1 x 2.5” SSD SATA (Half Slim)
Multi Level (MLC)
- 16GB
Storage
1 x 2.5” SSD SATA Multi Level (MLC) - 80GB, 120GB, 300GB
OS
Option
Embedded Enterprise (WEE):
- Microsoft® Windows® XP Professional (Eng, SP3 or SP2c)
- Microsoft® Windows® Server 2003/2008/2008R2 (Eng)
- Microsoft® Windows® 2003/2008/2008R2 (Eng)
- Microsoft® Windows® 7 Professional/Ultimate (Eng, SP1)
openSUSE® 11.4 (Linux)
Fedora™ 15 (Linux)
Ubuntu® 10.04 LTS
Ubuntu® 12.04 LTS
See also Accessories (HT 00300 MSOS) options.
Notes
- For Win7 OS, >1GB RAM + Review "SSD Selection Guide" in manual.
- 32bit or 64bit versions available where applicable.
Available Computer Configurations:
* IEC 60950 Compliant, 48VDC.
For a full overview of typenumbers, please review the following link:
www.hatteland-display.com/pdflink/ind100780-4.php
• JH C01MF A-A
: 1 x USB Cable 1m, TypeA-Chassis mount receptacle
• HT 00262 OPT-A1 : 4 x RS-422/RS-485 isolated, USB ext. module)
• HT 00263 OPT-A1 : 4 x RS-232 COM non-isolated, USB ext. module
• HT 00264 OPT-A1 : 1 x CAN isolated, 2 channel, USB ext. module
• HT 00273 OPT-A1 : 4 x Digital IN/OUT isolated, USB ext. module
• HT 00274 OPT-A1 : 2 x LAN 10/100Mbps, RJ45, USB ext. module
• HT 00300 MSOS
: OS options ->
http://www.hatteland-display.com/os
Please see user manual/datasheet for more information
Available Accessories:
• Projected Capacitive Touch Screen (Multitouch, USB interface)
Factory Defaults: