Hanna Instruments HI 91610C - Manual (Page 10)

19 18
PRINTING/LOGGING WITH HI 91610
To print the values shown on the display, press
PRINT.
This function can be activated in normal operation mode as well as
during logging (and scanning) modes.
When in the measurement mode, each printout provides the following
information:
a – Running sample number
b – Date (DD-MM-YY)
c – Time (HH.MM)
d – RH% value
e – Temperature value
LOGGING MODE WITHOUT PRINTING
This function is particularly useful when measurements have to be
taken continuously even in the absence of an operator over a long
period of time. In this mode data will be stored directly into memory.
Set the appropriate logging interval.
Press the ALT and LOG keys simultaneously to enter the logging
mode. The current log number and remaining page numbers will
appear for a few seconds on the display to indicate the correct
operational mode. The printer will print a complete set of data and
the "LOG" symbol will appear on the secondary LCD.
Press the ALT and PAPER keys at the same time and the "LOG"
symbol on display will start to blink.
If no key is pressed, after approximately 5 minutes the display will
switch itself off but the logging function remains active.
PRINT
Press the RANGE key to read the temperature on
the primary display.
If no key is pressed, after approximately 5 minutes, the meter goes in
standby mode to save the battery life.
Note: If PRINT is pressed while still in recording mode, a printout is
produced without affecting the running number.
Printing during recording
TO STOP RECORDING
To exit the recording mode, press ON/OFF. The instrument will make
one final exit printout.
The running log number can be reset by simply removing the
batteries.
RANGE
1 0 - 0 1 - 9 6
0 0 0 5 M
- - 0 5 - - * 1 1 . 5 1
6 5 . 2 R H %
2 5 . 0 ° C
PRINT
<>
1 0 - 0 1 - 9 6
- - 0 1 - - 0 0 0 5 M
0 0 0 6 * 1 2 . 0 1
6 5 . 1 R H %
2 5 . 0 ° C ON/OFF
1 5 - 0 1 - 9 6
0 0 0 1 * 1 1 . 2 0
6 5 . 6 R H %
2 5 . 0 ° C
<>
a
b
c
d
e
UP DOWN
TIME LOG
ALT
RANGE
UP
PAPER
ALT
PRINT