Hanna Instruments HI 4321 - Manual (Page 36)

36
TDS TDS TDS TDS TDS SETUP SETUP SETUP SETUP SETUP
The TDS Setup menu allows the user to set the parameters related to the TDS measurement.
Accessing TDS Setup
• Press
while in Measure mode and then to
select TDS range.
• Press and then to access TDS Setup menu.
To access a TDS Setup option:
• Use
or to highlight the desired option.
• Press to access the selected option.
The following is a description of the TDS Setup option screens.
Reading Mode - see Resistivity Setup section.
Profile - see Conductivity Setup section.
Temperature - see Conductivity Setup section.
Units
This option allows the user to set the TDS measuring range
ppm(mg/L), ppt (g/L), AutoRanging
To select the suitable unit:
• Use
or to highlight the TDS Units .
• Press to confirm and then use or
to highlight the desired range option.
• Press to confirm your selection or press to
cancel operation.