Hamilton Buhl FlashSign Software - Manual (Page 25)

25 / 26
Chapter Four: Installation
4.1 Bracket installation on wall:
Follow the instructions located on the back of the bracket already fitted on to the back of the Ad
Player.
You will need to remove this bracket to install it on the selected wall surface.
•
Mark out the place where the bracket is going to be positioned on the wall
•
Depending on where the unit is going to be installed, you will need either:
o Metal Plasterboard anchors and screws x 4 (for hanging on Plasterboard walls)
o (Please note that the unit weighs approx 8.5KG so you will need to ensure that each
plasterboard anchor has a minimum load capacity of 5 KGS-it is better to over
compensate)
o Wood screws(for attaching to studs or wooden frames)
o Nylon anchors (for attaching to brick or mortar)
•
You should always try and attach the bracket to at least 2 stud points for maximum
safety-use a reliable stud finder to do this
•
Also use a electrical wire finder to ensure you stay clear of any electrical wiring
•
If in doubt please consult a qualified tradesman or get professional advice from your local
hardware store
•
Drill holes into the nominated area, taking care not to puncture electrical wiring
•
Secure the bracket to the wall