Hamilton Buhl FlashSign Software - Manual (Page 14)

14 / 26
Two settings: "Same Setting" and "Set by Week Mode".
When you select "Set by Week", open On/Off Time Setup to set time by week mode.
When select "Same Setting", open On/Off Time Setup to set time by same mode.
1. Press DOWN button in Main Menu to select “On/Off Time Setup" and then press
“Play/Pause” button to enter “On/Off Time Setup” page.
2. Select “ON/OFF CONTROL MODE”, Move the cursor to right side by pressing RIGHT
button, and select the “ON/OFF MODE” by pressing UP /DOWN button and confirm the option by
pressing Play/Pause button.
3. Press LEFT button to return to “ON/OFF CONTROL MODE”.
4. Select “HOMEPAGE” by pressing DOWN button to return to the main menu.
Three Settings：Normal on, Normal off and Time On/Off
Normal On：The unit will be on while the power is on. Even if you shutdown the unit using the
remote controller, the system will start automatically 2 minutes later.
Normal Off：The Poster will be shutdown automatically when countdown 1 minute after the
power is on or started by controller.
Time On/Off：There are three groups of settings in this function. Set the time by pressing UP
/DOWN button.
Same Setting:
1. Press DOWN button in Main Menu to select “On/Off Time Setup” and then press
“Play/Pause” button to enter “On/Off Time Setup” page.
2. Select “ON/OFF CONTROL MODE”, Move the cursor to right side by pressing RIGHT
button, and select the “Same Setting Mode” by pressing UP /DOWN button and confirm the option
by pressing Play/Pause button.
3. Select “Same Setting” by pressing DOWN button to enter the page of “ON/OFF Same
Setting”.
4. There are three groups of settings in Time Setup, and you can separately set "Enable” or
“Suspend” for each group of setting , select the item needing modifying by pressing LEFT/RIGHT
button , and adjust the time by pressing UP /DOWN button.