Hall Research UVA-WP - Manual (Page 7)

Wallplate VGA and Audio on UTP Transmitter
5
2.2 Installation into a Wall, Desk or Podium
• If you will be using a PC or notebook, test the transmitter and
receiver with a short Cat5 cable to ensure there is enough
power from your Video source to power up the transmitter. In
that case you may decide to not hook- up a power supply.
However, Hall Research Technologies recommends that you
hook up a power supply to the transmitter, so that if a source
with no power is encountered, you will still be able to transmit
the signal.
• For new construction, you need a single gang switchbox of
any depth (since the unit is shallow).
For retrofit, or in countries where the size of single gang box
is not the same as the unit, you need to install a switchbox in
to the wall or podium. -E or -U units are shipped with such a
box, or you can order one from Hall Research (920-WB-
B114R-UPC) or get one from your local hardware store.
Check your local electrical codes to ensure compliance.
Single-gang Retrofit Switchbox