Hall Research UVA-WP - Manual (Page 11)

Wallplate VGA and Audio on UTP Transmitter
9
Connect the remote monitor and speakers to the URA or another
compatible receiver unit (as shown above) and attach the power
supply to the receiver.
CAUTION
Before plugging in the remote monitor, verify that the AC line is properly wired and that a
protective ground (green) wire is established with NO potential difference between both the
sender and receiver locations. The splitter can tolerate up to 5 vPeak-Peak ground potential
between the two locations. Failure to ensure good grounding can result in erratic operation and
possible shock hazards or damage to your equipment.
2.5 Adjusting Cable Length Compensation
Compensation
Adjustment
Older Versions
Newer Versions