Status – Hall Research UHBX-3S User Manual

Page 8

UHBX-3S Software Guide

receiver. By default, it is the HDBaseT mode.



Long Reach - When set to Long Reach, the HDBaseT output will have the

strongest signal from the sender to the receiver. However, this mode does not

support deep color or 4K video.

2.4. Status

The UHBX-3S Manager provides you an instant status update on input video, the

HDBaseT connection, and the current EDID passed to the video source.

The input video status is indicated by an LED on/off. When the

LED is on, it means the indicated video type is detected. If the

LED is off, no video input is received.

Input Video

The HDCP LED is on/off when input video has HDCP Encryption

enabled/disabled.

The HDBaseT status is also indicated by

an LED on/off. When the LED is on, it

means the indicated HDBaseT connection

is detected; otherwise, its LED is off.

HDBaseT

The cable length is measured in meters,

and it is not applicable when the connection

is in Long Reach mode. The calculation

may vary according to cable quality.

The data shown in the EDID table is periodically scanned to ensure the checksums for

each block is valid. When an invalid checksum is detected, the last byte (location 256)

will be highlighted. This invalid checksum can cause connectivity problems.

EDID Table

When the Link LED is flashing, it is indicating the HDBaseT extender

module at the specified output is in Low Power mode due to either +5V

video source or HPD sink LCD being not detected.