Hall Research UHBX-3S - Manual (Page 10)

UHBX-3S Software Guide
8
© Copyright 2014. Hall Research, Inc.
All rights reserved.
2.7. Tool Bar Menu
The UHBX-3S Manager consists of three main menus, which allow you to easily perform
more specific desired tasks.
The File menu consists of the Exit selection as
shown.
File

Exit – Exit the UHBX-3S Manager.
The Tools menu consists of the following menu items as shown.
Tools

Factory Defaults – Restore the device to
factory default settings.
 Import EDID – Import an EDID (256-byte
binary into the unit).
 Export EDID – Save the current EDID as a
256-byte binary file. This file can be edited
as reloaded using Import EDID tool
selection.

HDBaseT Programmer – Can be used to update any HDBaseT extender module.

Firmware Update – Allow you to update any future device firmware.
The Help menu has the About selection as shown.
Help

About… - Display the current version of
UHBX-3S Manager, device firmware, and USB
serial number.
2.8. HDBaseT Programmer
The HDBaseT Programmer is only supported by the UHBX-3S firmware version 1.2 or
later. This HDBaseT programmer can be used to program the local HDBaseT extender
modules inside the UHBX-3S device. There are a total of 3 modules, and one module is
used at each HDBaseT ouput.
The HDBaseT Programmer can be found under the Tools menu. When the HDBaseT
Programmer is selected, the UHBX-3S Manager will open an HDBaseT Programmer
window as shown below.