Using the software, General, Usb device detection – Hall Research UHBX-3S User Manual

Page 4

UHBX-3S Software Guide

2. Using the Software

2.1. General

The UHBX-3S Manager is a Windows GUI that can be installed to remotely control and

monitor the UHBX-3S device via a USB connection. It also provides you an ability to

manage the EDID by learning it from a desired LCD monitor connected to any output,

importing any custom EDID into the device, exporting the device’s EDID to a file,

updating any future firmware into the device, and many more.

2.2. USB Device Detection

The UHBX-3S Manager automatically configures the USB port after connection to the

device (using standard Windows™ USB drivers) and does not require any special USB

drivers to be installed.
Once connected to a USB port, the Windows™ system will detect and use the

appropriate USB driver. The first time you connect the device to the PC, you may

experience a short delay and a windows notification pop-up message may be shown.



If no UHBX-3S device is attached to the PC, the on-screen fields are disabled

(grayed out)

This detection and driver installation only occurs when the UHBX-3S is

connected to the PC for the first time. Afterwards, reconnected devices

automatically configure themselves with no delay or message.