Hall Research UHBX-3S User Manual

Page 7

UHBX-3S

By default, Output 1 of each device starts with number 1, and this number will be

incremented by one for the next output. If Output 1 is changed to 12, the Output 2 and

Output 3 will be 13 and 14 respectively.

This output channel numbering is used to transmit/receive data to or from the specified

serial receiver.

Current Connection – Allow you to view

you to view the current output connection

that the controller is connected to in

addition to the baud rate, and the parity

that the controller is communicating at with

the remote serial receiver.



Cycle HPD - This button is used to send

500ms Hot Plug Detect pulse signal to the

video source. It has the same effect of

unplugging the HDMI input cable and

plugging it back in. This forces the source

Miscellaneous

to re-initialize its HDMI video output connection (read EDID, and implement HDCP if

required).



Power Management – When it is selected, the UHBX-3S device will check for the

presence of source +5V and sink HPD. If neither +5V nor HPD is detected, the

HDBaseT extender module at the output will be in low power mode. When it is not

selected, the HDBaseT extender module at the output will always be either in Auto

or Long Reach mode.

The output video can be blanked or un-blanked

by selecting the corresponding check box.

Video Blanked

The HDBaseT output can be individually set to

either Auto or Long Reach mode.

Set HDBaseT Mode



Auto - When set to Auto, the HDBaseT

output will follow the current mode on the