GoDEX EZ Viewer - Manual (Page 15)

3-2. EZ-Viewer Messages
LED Light LCD
Message Display Power Ready Error
Printer
Beep
Description
EZ-XXXX
Vx.xxx ! !
1
EZ-XXXX: printer model; Vx.xxx: current F/W version
Self Test
! !
3
Printer is in Self-Test Mode. Please refer to page 14 for
more information.
Now in
Dump Mode
! !
3
Printer is in Dump Mode. Please refer to page 15 for more
information.
Auto
Sensing mode
!
3
Printer is in Auto Sensing Mode. Please refer to page 15
for more information.
EZ-XXXX
Pause
! !
Printer has paused, press Pause key again to continue
printing.
Print job is
cancelled
! !
Cancel key pressed, stopping all the print jobs and clear
the printer data.
Press feed key to
continue print job
!
Press the Feed key to allow printer to continue with the
existing actions.
PROGRAM
LOADING
! !
Printer is downloading the firmware.
LOADING
COMPLETE
!
1
Firmware has been successfully downloaded.
Setting Mode
! !
1
Printer is currently in the Setting Mode. Please refer to
page
12 for more information.
Green Red
3-3. Self-Test
The Self-Test function in a printer will help the user to troubleshoot whether the printer is operating normally. In the
Self-Test Mode, the printer will print out a test sample each time when the Feed key is pressed. To stop the Self-Test
procedure in the middle, simply power off the printer.
Below are the Self-Test procedures:
1. Please refer to section 2-3 to connect the printer and EZ-Viewer.
2. Power off the printer, press and hold the feed key first.
3. Power on the printer (while still holding the Feed key); release the Feed key after hearing 3 beeps.
4. After about 1 second, printer would automatically print out the following, and the LCD Display would show “Self
Test.” This means the printer is operating normally.
Self-Test includes the internal printer data setting.
14