GoDEX EZ Viewer - Manual (Page 14)

13
Paper Setup
Default: Gap Paper
Black Mark: for label or plain paper with black mark in the back
Gap Paper: for labels with liner and gap, or hang tags. The default is set to be
gap paper.
Continuous: for continuous paper
Baud Rate: 4800/ 9600/ 19200/ 38400 /57600/115200 bits, Default: 9600 bits
Parity: None Parity / Odd Parity / Even Parity, Default: None Parity
Data Bits: 7 bits / 8 bits, Default: 8 bits
COM Port Setup
Stop Bits: 1 bits / 2 bits, Default: 1 bit
Auto Sensor
DefaultΚOFF
Black Mark Mode: detects black mark label
Gap Mode: detects gap paper
LCD Language
Default: English
English Simplified Chinese Traditional Chinese French
German Italian Spanish Turkish
Code Page Setup
Default: Code Page 850
Code Page 850
Code Page 852
Keyboard Setup
Default: US
US UK French German Spanish
Italian Finnish Dutch Belgian
Keyboard Mode
Recall Label ΚRecall EZ-1000 / EZ-1000Plus label from memory card.
Keyboard Setup ΚSetting the keyboard.
Code page Setup ΚSetting the code page.
Printing Option: Set the print quantity.
Exit KB Mode ΚExit PS2 KB Mode
Buzzer Setup Buzzer setting : ON/OFF, Default: ON
Smart Backfeed
Default: ON
ON: This function must install stripper or cutter.
OFF
Top of Form
Default: ON
ON: Start each printing from the Top-of-Form position.
OFF
Ethernet Go to default: Set the IP address of Ethernet module to factory default setting.
Preview: Preview and check all settings.
Note:
(1) “Default Setting” is the original settings from the factory, if other changes are made on the settings, then follow the
new settings.
(2) Printer will store the previous settings after power off, thus if settings are to be changed again, please enter the
Setting Mode to reset.