Glow-worm Ultimate 80FF - Manual (Page 16)

16 2000225233B
4 Flue and Appliance Preparation
4.12 Flue Assembly - Installation
If the boiler is not to be fitted for some time cover the hole in the
wall.
On limited access installations push the flue assembly into and
through the hole such that it is within the wall and does not stick
out into the room, see diagram 4.12. Do not push the flue
assembly too far into the holes as it has to be pulled back into
the boiler and secured.
4.13 Internal Access Flue
If access to the outside wall is not practical, the flue system can
be installed from inside. Use of the optional wall liner kit is
required.
Diagram 4.11
Diagram 4.12
FOAM
SEAL
FOAM
SEAL
WALL THICKNESS-
OVER 300mm
10mm
WALL THICKNESS-
UP TO 300mm
Q-25mm
Q
Q
GASKET
(PRE-ATTACHED)
6832
4082
;
;
;
;
; ;
Diagram 4.13
6930
Diagram 4.14
6931
FOAM
SEAL
"A"
REAR FITTING
SIDE FITTING
FOAM
SEAL
WITH WALL LINER KIT ONLY