Glow-worm Clearly Solar Vertical In-Roof Collector - Manual (Page 41)

41
9 Three Collector Flashing Kit - 15 0 - 22 0
15040
9.2 Ridge Plates
Refer to diagram 9.13 and drill holes in the left ridge plate
passing through the holes in the right ridge plate.
Apply silicone to the overlapping parts of the ridge plates.
Rivet the ridge plates together.
Slide the ridge plates on the collectors.
Make sure that the ridge plates are above the side sections
and slip in the corresponding rail ( A).
Fix the ridge plates to the roof battens with the screws (No. 1)
using the supplied Torx bit.
9.3 Riveting the frame
Drill a 4.5 mm diameter hole through the ridge plates on the
marks on the left and right hand respectively, see diagram
9.14.
Rivet the ridge plate to the side section.
RIDGE PLATE
Diagram 9.13
Diagram 9.14
15042
4,5
A