Glow-worm Clearly Solar Vertical In-Roof Collector - Manual (Page 21)

21
Diagram 6.17
14963
4,5
6.3 Riveting the frame
Drill a 4.5 mm diameter hole through the ridge plates on the
marks on the left and right hand respectively, see diagram
6.17.
Rivet the ridge plate to the side section.
6.4 Tile Bars
Place the tile bars on the ridge plates.
Bend the metal bands and hook the tile bars to the roof batten
from the top, see diagram 6.18.
6.5 Covering the profile ends
Cover the side profile ends and the collector joints with the
profile end pieces, see diagram 6.1 for profile end location.
Fit the profile end pieces to the bottom collector edge and
then tilt them up, until they lock in the upper collector edge,
see diagram 6.19.
6 Two Collector Flashing Kit - 22 0 - 75 0
Diagram 6.18
14964
TILE BAR
TILE BAR
STRAP
Diagram 6.19
14981
PROFILE END PIECE
COLLECTOR
EDGE