beautypg.com

Warnings, Important information, Manual handling – Glow-worm Clearly Solar System Hydraulics User Manual

Page 4

background image

4

Installation and Use Regulations

In your own interests and that of safety, it is the LAW that this

product is installed by a

competent person in accordance

with the current issue of these regulations.
Local authority planning permission may be required for the

installation. The local authority should be notified.

Control of Substances Hazardous to Health

Under Section 6 of The Health and Safety at Work Act

1974, we are required to provide information on substances

hazardous to health.
The adhesives and sealants used in this product are cured

and give no known hazard in this state.
Solar fluid safety data, see section 9.

Manual Handling

With regards to the “Manual Handling Operations, 1992

Regulations”, the appliance exceeds the recommended

weight for a one man lift, refer to section 9 for more

information.

Electrical Supply

The product MUST be earthed.

All system components shall be of an approved type and all

wiring to current I.E.E. wiring regulations.
External wiring must be correctly earthed, polarised and in

accordance with the relevant standards.
In GB, this is BS 7671.
In IE, this is the current edition of ETCI rules.

The product MUST be connected to a permanent 230V ac,

50Hz supply.

Testing and Certification

This product is tested and certificated for safety and

performance. It is, therefore, important that no alteration is

made to the product, without permission, in writing, by Glow-

worm.
Any alteration not approved by Glow-worm, could invalidate

the certification, warranty and may also infringe the current

issue of the statutory requirements.

CE Mark

The CE mark on this product indicates that it complies with

the basic requirements of the applicable directives as stated

on the data badge.

“Benchmark scheme”

Glow-worm support the Benchmark initiative. It is very

important that the service record is completed by the

installation engineer and handed over to the user.

WARNINGS

SAFETY

The system must be installed by a competent person, who is responsible for adhering to

the existing standards and regulations.

ALTERATIONS

Under no circumstances should you ever attempt to make alterations to these

components or any other part of the system

SEALED COMPONENTS

Under no circumstances must the user interfere with or adjust sealed parts.

Important Information