FeiYu Tech FY-41AP - Manual (Page 23)

Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [email protected]
- 23 -
Install propeller
In order to install the propeller, please follow the motor rotation direction
according to the pictures found in the ―Motor Mixer‖ section on page 20 of this
manual.
Attempt to fly
To use the default control parameters, execute Combination Stick Commands
(CSC) in stabilized mode and takeoff. Manually control the aircraft and attempt to
hover at the height of about 1 meter. Get a feel for the attitude stability, and then
manually change the attitude through your RC, and then loosen the RC sticks and
observe the aircraft auto-recovery levels and retention capacity. If improper, then
land the aircraft and perform further debugging.
Check the control direction of RC corresponding channel
After installation is complete, please execute Combination Stick Commands
(CSC) in stabilized mode (Can not in Hovering mode or Auto Return To Launch
Mode(RTH) ) to start motors. Slowly push the throttle but do not take off. Check the
control surfaces of the joystick remote control and make sure the aircraft direction is
correct.