EXFO MAX-700 - Manual (Page 66)

Testing Fibers in Auto Mode
54 MAX-700
6. Select the boxes corresponding to the desired test wavelengths. You
must select at least one wavelength.
7. If you want to clear the settings the OTDR has determined to start with
a new set of OTDR settings, press Reset.
8. Press Start.
If the first connector check feature is enabled, a message will appear if
there is a problem with the injection level (see Enabling or Disabling
the First Connector Check on page 48).
9. Once the analysis is complete, save the trace by pressing Quick Save
in the button bar.
The application will use a file name based on the autonaming
parameters you defined (see Naming Trace Files Automatically on
page 44). This file name appears at the top of the graph and at the top
of the linear view table.
Note: The application will only display the Save File dialog box if you have
activated the feature to always be prompted when you save a file. From
this dialog box, you can change the location, the file name and the file
format.
9a. If necessary, change the folder to which the file will be saved by
pressing the Location button.
9b. If necessary, specify a file name.
10. Press OK to confirm.
I
MPORTANT
If you specify the name of an existing trace, the original file will be
overwritten and only the new file will be available.