EXFO MAX-700 - Manual (Page 201)

Creating and Generating Reports
MAX-700 189
Generating a Report
Test and Cable Setup for main and reference traces:
file name, OTDR model, software version, wavelength,
distance, IOR, RBS, acquisition time, pulse width, file
type, serial number, splice loss detection, reflectance
detection, end-of-fiber detection, and helix factor.
By default, this item is selected.
X X
Comments
By default, this item is selected. X X
Link measurement: Span loss, Span length, Average
loss, Average splice loss, and Span ORL.
By default, this item is selected.
X X
Markers: marker information: a, A, b, B, and A to B
distances, as well as A to B attenuation, loss, and ORL.
By default, this item is selected.
X
Event table: If you selected the Mark faults in event
table feature from the OTDR setup, the failed results
will appear in red and bold on a white background.
Otherwise, they will not be “highlighted”.
By default, this item is selected.
X X
Pass/Fail thresholds: loss, reflectance, fiber section
attenuation thresholds as they are defined in OTDR
setup, under Event table.
Note: Selecting this item will not highlight the
failed results in the report. You must
configure the application to display fail
or warning results from the OTDR setup
and include the Event table item in your
report.
X X
Item appearing on the report
Auto
mode
Advanced
mode