ENMET MX-32 - Manual (Page 24)

ENMET Corporation MX32 E NGUARD
20
5.5 Changing Access Code
This menu allows MX32 C ONTROL unit access code to be changed.
See section 5.1.1 to enter a valid access code to enter the maintenance menus. Press the + switch to move through the
maintenance menus until the % COD is flashing.
Press ENTER switch while the % COD is flashing to enter the access code menu.
The current access code is displayed.
1. Press + or – select value of digit, press ENTER to move to next digit. When access code is complete, press ENTER.
Press + or – to select
value of digit
Press ENTER to
move to next digit %
1270
cod
Press + or – to select
value of digit
Press ENTER to move to
next digit
%
8888
cod
When access code is
complete,
press ENTER.
Then the request to save new access code is displayed.
2. Press + or – to select OUI (yes) or NON (no). To update the access code, Press ENTER
If you select NON and press ENTER the new access code will not be updated.
If you select OUI and press ENTER the new access code be updated.
Press + or – to
select yes or no ▲
enrg oui
Press ENTER when
correct choice is selected
▲
0 co
Next the MX32
Control returns to the
normal display mode.
If the access code is invalid, the display will return to the normal mode.
If the access code is valid, the display will enter the maintenance menus
5.6 Buzzer menu
This menu allows MX32 C ONTROL unit to set the buzzer (horn) active or inactive.
See section 5.1.1 to enter a valid access code to enter the maintenance menus. Press the + switch to move through the
maintenance menus until the BUZ is flashing.
1. Press ENTER switch to enter the Buzzer menu.
Press ENTER
buz
2. Press + or – to select ON (buzzer active) or OFF (buzzer is non-active). Press ENTER
Press + or –
to select buzzer
setting
Yes BUZ
When the buzzer
setting is correct,
Press ENTER
3. Press + or – to select OUI (yes) or NON (no) for buzzer setting to be updated. Press ENTER
If you select NON and press ENTER the buzzer setting will not be updated.
If you select OUI and press ENTER the buzzer setting will be updated.
Press + or – to
select yes or no ▲
enrg
oui
Press ENTER when
correct choice is selected
4. Buzzer setting is complete, the MX32 C ONTROL display returns to normal display mode.
▲
0
co