ENMET MX-32 - Manual (Page 21)

MX32 E NGUARD ENMET Corporation
17
5.3 Initialization (INI) menu
C AUTION : This procedure is not used with 4 – 20mA Sensor/Transmitters. Continue to the next
menu.
This menu is used to automatically I NITIALIZE the measurement curve managed by the microprocessor of sensor
connected to the channel.
Initialization should be done when the unit is first installed and when a cell or sensor is replaced.
See section 5.1.1 to enter a valid access code to enter the maintenance menus. Press the + switch to move through the
maintenance menus until the INI is flashing.
1. Press ENTER switch while INI is flashing to enter initialization menu
Press ENTER
ini
Next the channel indicator is flashing.
2. Press + or – to Select channel to be initialized.
When the channel indicator is correct. Press ENTER
▲
ini
Next the save initialization display is flashing
3. Press + or – to select OUI (yes) or NON (no) for channel initialization to be updated. Press ENTER
Press ENTER ▲
enrg
oui
4. Initialization is complete the MX32 Control display returns to normal display mode.
▲
0
co