ENMET PROAIR 2200 - Manual (Page 4)

P RO A IR 2200 ENMET Corporation
1
1.0 Introduction
The P RO A IR 2200 is a compressed air monitoring instrument that measures and detects certain hazards in compressed air
supply systems. The instrument is available with up to 4 internal sensors. Available sensors include, but are not, limited to
carbon monoxide (CO), carbon dioxide (CO
2
), Hydrocarbons (HC), for variations in the oxygen (O
2
) content and for dew point.
The sensors can be used alone or up to four sensors can be used together. In the instrument, a sample of the compressed air is
passed over each sensor and the resulting electrical outputs are used to evaluate the air for the target gases.
The
P RO A IR 2200 is a highly adaptable instrument. Some adaptations require an addendum be added to the manual to
facilitate use of the instruments with these adaptations. If addendum is needed, see page(s) between sections replacement part
numbers and warranty.
Some features of the instruments are as follows:
continuous monitoring of the sample air
continuous LCD display of gas and vapor concentrations
menu driven operational and maintenance controls
menu driven calibration procedure
audio and visual alarms indicate unsafe conditions
alarm relay contacts available on terminals
a fault relay and visual fault alarm
low air flow fault indication and display
alarm acknowledgement capability including audio defeat
mA outputs for each target gas
Hydrocarbons (HC) are limited to gases with an ionization potential of 10.6 eV or less. See Appendix B for a list of gases and
IPs.
N OTE : All specifications stated in this manual may change without notice.
1.1 Unpack
Unpack the P RO A IR 2200 and examine it for shipping damage. If such damage is observed, notify both ENMET customer service
personnel and the commercial carrier involved immediately.
Regarding Damaged Shipments
N OTE : It is your responsibility to follow these instructions. If they are not followed, the carrier will not honor
any claims for damage.
This shipment was carefully inspected, verified and properly packaged at our company and delivered to the carrier in good condition.
When it was picked up by the carrier at ENMET , it legally became your company’s property.
If your shipment arrives damaged:
•
Keep the items, packing material, and carton “As Is.” Within 5 days of receipt, notify the carrier’s local office and request
immediate inspection of the carton and the contents.
•
After the inspection and after you have received written acknowledgment of the damage from the carrier, contact ENMET Customer
Service for return authorization and further instructions. Have your Purchase Order and Sales Order numbers available.
ENMET either repairs or replaces damaged equipment and invoices the carrier to the extent of the liability coverage, usually $100.00.
Repair or replacement charges above that value are your company’s responsibility.
The shipping company may offer optional insurance coverage. ENMET only insures shipments with the shipping company when
asked to do so in writing by our customer. If you need your shipments insured, please forward a written request to ENMET
Customer Service.
Regarding Shortages
If there are any shortages or questions regarding this shipment, please notify ENMET Customer Service within 5 days of receipt at the
following address:
1.2 Check Order
Check, the contents of the shipment against the purchase order. Verify that the P RO A IR 2200 is received as ordered. If there are
accessories on the order, ascertain that they are present. Check the contents of calibration kits. Notify ENMET customer service personnel of
any discrepancy immediately.
1.3 Serial Numbers
Each P RO A IR 2200 is serialized. These numbers are on tags on the equipment and are on record in an ENMET database.
ENMET Corporation
680 Fairfield Court
Ann Arbor, MI 48108
734-761-1270 734-761-3220 Fax