Elenco 30MHz Dual Trace - Manual (Page 34)

31
!
0
1
1. Symbol Indicators:
2. Operating Controls, Indicators and Signal input connectors:
(P.25~30)
GENERAL FUNCTION CONTROLS
ON Indicator(32): Lights when oscilloscope is “on”.
POWER Pushbutton(30): Turns oscilloscope “on” and “off”.
INTENSITY Control(31): Adjusts to maintain trace at a horizontal position.
TRACE ROTATION Control(29): Adjusts to maintain trace at a horizontal
position.
FOCUS Control(28): Adjusts trace focus.
20 MHz/100 MHz Pushbutton(33): When released, selects 100MHz
bandwidth. When engaged, limits bandwidth to 20 MHz.
COMPONENT TEST Pushbutton(3): With pushbutton set to “in” position,
Component Test mode is enabled. Normal scope operation is enabled with
pushbutton in “out” position.
COMPONENT TEST Jack(6): “Banana”-type HI-side input jack for connection
to component in Component Test operation mode.
GND Terminal(8): Oscilloscope chassis ground jack, and earth ground via
three-wire ac power cord.
C
Power OFF
Power ON
Vertical Up
Vertical Down
Horizontal Left
Horizontal Right
Earth Ground
Warning! Risk of Danger
VR With Switch
Conforms to IEC 1010. EN 61010
Complies With U.S. & Canadian
Standard
In Spected & Incensed by TUV
Product Servies
CONTROLS AND INDICATORS
..