Echelon LNS Plug-in User Manual
Page 44
The following table lists the standard LNS plug-in commands.
Command
Description
LcaCommandBrowse
20
Monitor and control the object.
LcaCommandBuildImage
10
Build the image for the object. Only applies to
AppDevice class objects.
LcaCommandCalibrate
14
Set calibration configuration properties for an
object.
LcaCommandCommission
11
Load the network image into an object. Only
applies to AppDevice class objects.
LcaCommandConfigure
13
Set the configuration properties for an object.
LcaCommandConnect
15
Connect an object to other objects. Only applies to
AppDevice and Subsystem class objects.
LcaCommandControl
22
Control the object.
LcaCommandEditSource
2
Edit source code for the object. Only applies to
AppDevice class objects.
LcaCommandLoad
12
Load an application image into an object. Only
applies to AppDevice class objects.
LcaCommandMonitor
21
Monitor the object.
LcaCommandMonitorRecovery
61
Monitor recovery of an object.
LcaCommandNew
1
Create a new object of the specified class with the
specified name.
LcaCommandOffline
31
Change the state of the object to offline.
LcaCommandOnline
30
Change the state of the object to online.
LcaCommandRecover 60
Recover
object.
LcaCommandRegister 50
Register
a component with the object.
LcaCommandReplace 41
Replace
the
object with a new object.
LcaCommandReport
23
Generate a report for the object.
LcaCommandReset
32
Reset the object.
LcaCommandSecurityLevel
70
Set the security level for an object
LcaCommandTest 33
Test
the
object.
LcaCommandUninstall 40
Uninstall
the
object.
LcaCommandUnregister 51
Unregister
the
component.
LcaCommandWink
34
Wink the object. Only applies to AppDevice and
Router class objects.
Note: Plug-ins can also implement custom commands. The values for custom command values are
assigned by the plug-in, and may be any value greater than or equal to LcaCommandUserStart
(10000).