Trencher, Rt80q operator’s manual – Ditch Witch RT80 User Manual
Page 174
RT80Q Operator’s Manual
Service - 173
As Needed
Trencher
Replace Digging Chain
Visually check digging chains for wear on teeth
(1), rollers, and sidebars (2). Check pins (3) and
bushing wear by measuring distance between
chain pins and comparing it with a new chain.
To remove chain:
1.
Fasten and adjust seat belt.
2.
Start tractor. See page 74 for proper start-up
procedures.
3.
Move attachment direction/speed control until digging chain connector pin is on top of boom.
4.
Lower boom to ground.
5.
Engage parking brake and verify parking brake indicator is on.
6.
Turn ignition switch to STOP.
7.
Secure chain by clamping links on either side
of connector pin with chain jaws. Squeeze
jaws to reduce pressure on connector pin.
IMPORTANT: Replace sprockets when a new
chain is installed.
- JT5 (161 pages)
- JT922 (159 pages)
- JT9 (165 pages)
- JT20 (195 pages)
- JT1220 (201 pages)
- JT2020 (203 pages)
- JT25 (203 pages)
- JT30 (245 pages)
- JT60 (218 pages)
- JT100 (243 pages)
- AT Air Hammer (11 pages)
- TK Series Manual (61 pages)
- 8500 (77 pages)
- MR90 (121 pages)
- FT5 (28 pages)
- FM5 (57 pages)
- FM13V (46 pages)
- FM25 (67 pages)
- P80 (71 pages)
- OnGrade (63 pages)
- FX20 (100 pages)
- FX25 (119 pages)
- FX30 (149 pages)
- FX50 (141 pages)
- FX60 (157 pages)
- MV800 (111 pages)
- RT Line (115 pages)
- RT30 (97 pages)
- RT45 (203 pages)
- RT55 (177 pages)
- RT100 (161 pages)
- RT115 (252 pages)
- RT120 (223 pages)
- Zahn (105 pages)
- RT115 Q (193 pages)
- RT120 Q (211 pages)
- 100SX (50 pages)
- 410SX (131 pages)
- SK350 (77 pages)
- SK750/SK755 (81 pages)
- SK850 (107 pages)
- SK850 Footings Machine (107 pages)
- 150RT (55 pages)
- 250RT (49 pages)