Normal use, Rt80q operator’s manual – Ditch Witch RT80 User Manual
Page 113
Saw - 112
RT80Q Operator’s Manual
Operation
CMW
Normal Use
1.
Fasten and adjust seat belt.
2.
Start tractor. See “Start Unit” on page 74 for start-up procedures.
3.
Drive to starting point. Move in line with planned trench.
4.
See manufacturer’s instructions for saw operating procedures.
5.
Engage parking brake.
6.
Move gearbox control to 1 (low).
7.
Swivel seat to the desired position.
8.
Engage axle lock.
9.
Lower saw to just above ground.
10. Slowly lower saw to desired depth.
11. Check that saw is in line with planned trench.
12. Release parking brake.
13. Move ground drive control to desired speed.
14. Work slowly and carefully.
15. When trench is complete, move ground drive control to neutral and adjust throttle to low idle.
See also other documents in the category Ditch Witch Special machinery:
- JT5 (161 pages)
- JT922 (159 pages)
- JT9 (165 pages)
- JT20 (195 pages)
- JT1220 (201 pages)
- JT2020 (203 pages)
- JT25 (203 pages)
- JT30 (245 pages)
- JT60 (218 pages)
- JT100 (243 pages)
- AT Air Hammer (11 pages)
- TK Series Manual (61 pages)
- 8500 (77 pages)
- MR90 (121 pages)
- FT5 (28 pages)
- FM5 (57 pages)
- FM13V (46 pages)
- FM25 (67 pages)
- P80 (71 pages)
- OnGrade (63 pages)
- FX20 (100 pages)
- FX25 (119 pages)
- FX30 (149 pages)
- FX50 (141 pages)
- FX60 (157 pages)
- MV800 (111 pages)
- RT Line (115 pages)
- RT30 (97 pages)
- RT45 (203 pages)
- RT55 (177 pages)
- RT100 (161 pages)
- RT115 (252 pages)
- RT120 (223 pages)
- Zahn (105 pages)
- RT115 Q (193 pages)
- RT120 Q (211 pages)
- 100SX (50 pages)
- 410SX (131 pages)
- SK350 (77 pages)
- SK750/SK755 (81 pages)
- SK850 (107 pages)
- SK850 Footings Machine (107 pages)
- 150RT (55 pages)
- 250RT (49 pages)