Position tractor, Attach product, Rt80q operator’s manual – Ditch Witch RT80 User Manual
Page 100
RT80Q Operator’s Manual
Plow - 99
Setup
CMW
Position Tractor
1.
Fasten and adjust seat belt.
2.
Start tractor. See page 74 for start-up procedures.
3.
Drive to starting point. Move in line with planned trench.
4.
Engage parking brake and verify parking brake indicator is on.
5.
Lower backfill blade, if equipped.
6.
If equipped with combo, select the plow control position.
7.
Lower plow to starting point of trench.
8.
Turn ignition switch to STOP.
Attach Product
To Pull Product
1.
Insert material into pulling grip.
2.
Tape grip with duct tape.
IMPORTANT: If material must be at a constant depth, dig starting and target trenches.
NOTICE: Keep everyone away from
material being installed.
See also other documents in the category Ditch Witch Special machinery:
- JT5 (161 pages)
- JT922 (159 pages)
- JT9 (165 pages)
- JT20 (195 pages)
- JT1220 (201 pages)
- JT2020 (203 pages)
- JT25 (203 pages)
- JT30 (245 pages)
- JT60 (218 pages)
- JT100 (243 pages)
- AT Air Hammer (11 pages)
- TK Series Manual (61 pages)
- 8500 (77 pages)
- MR90 (121 pages)
- FT5 (28 pages)
- FM5 (57 pages)
- FM13V (46 pages)
- FM25 (67 pages)
- P80 (71 pages)
- OnGrade (63 pages)
- FX20 (100 pages)
- FX25 (119 pages)
- FX30 (149 pages)
- FX50 (141 pages)
- FX60 (157 pages)
- MV800 (111 pages)
- RT Line (115 pages)
- RT30 (97 pages)
- RT45 (203 pages)
- RT55 (177 pages)
- RT100 (161 pages)
- RT115 (252 pages)
- RT120 (223 pages)
- Zahn (105 pages)
- RT115 Q (193 pages)
- RT120 Q (211 pages)
- 100SX (50 pages)
- 410SX (131 pages)
- SK350 (77 pages)
- SK750/SK755 (81 pages)
- SK850 (107 pages)
- SK850 Footings Machine (107 pages)
- 150RT (55 pages)
- 250RT (49 pages)