Ditch Witch Zahn - Manual (Page 47)

Transport - 46
R150/R230/R300 Operator’s Manual
Haul
CMW
Haul
Load
1. Disengage parking brake.
2. Start engine and slow to low throttle.
3. Pull front end lift control to raise front end clear of trailer, but keep it low.
4. Move unit to rear of trailer and align with ramps.
5. Move ground drive control forward and slowly
move unit onto trailer until tiedown position is
reached.
6. Push front end lift control to lower front end to
trailer bed.
7. Engage parking brake and turn ignition switch
to OFF.
8. Lock articulation joint.
9. Close fuel tank shutoff valve (shown).
10. Tie down unit.
IMPORTANT: For trailer information, see the trailer manufacturer’s manual.
Crushing weight. If load falls or moves it could kill or crush you. Use
proper procedures and equipment or stay away.
Tipover possible. Machine can tip over and crush you.
• Always operate with heavy end uphill.
• Lock articulation joint when transporting.
IMPORTANT: Do not remove front end from InterChange connection before loading or unloading power
unit.
NOTICE:
• If loading onto tilt-bed trailer, be
prepared for trailer bed to tilt.
• Move all controls to neutral position
when stopped.