DaySequerra NLC5.1ST - Manual (Page 26)

26
NLC5.1ST User Manual
Output 1-2: Allows for testing of the internal signaling circuit within NLC5.1ST. The two fields displayed
represent each output, 1 and 2, respectively. When set to ON, the relay will close. Input 1-4: Shows the
current state of the GPIO inputs. Four fields display the status of each GPIO input, 1-4, respectively.
ON is only shown when a signal has been detected.
Alarms Menu
Channel Loss Alarms: When enabled, NLC5.1ST will monitor the configured channel pairs for audio
loss. The sub-menu contains on/off controls for each channel pair and the ALARM DELAY TIME which
is defaulted to 5 sec. (Default: Off for each channel pair)
AES Error: When enabled, NLC5.1ST will alert the operator on any AES errors. (Default: Off)
Power Supply: When enabled, NLC5.1ST will alert the operator for a power supply issue. (Default: Off)
About Menu
Model Number: Displays the model number of the unit.
Serial Number: Displays the serial number of this NLC5.1ST.
Hardware Rev: Displays the hardware revision level of this unit.
Firmware Rev: Displays the firmware revision level that is running on this unit.
DTS Algorithm: Displays the specific DTS algorithm running.
DTS Algorithm Rev: Version of the DTS algorithm running on this unit.
GPIO Test Menu Screen
Alarms Menu Screen