DaySequerra NLC5.1ST - Manual (Page 19)

NLC5.1ST User Manual
19
MEDIUM PRESET - Medium preset has higher Ratios
but slower release times. This allows for full correction
to be applied but overcomes a ‘nervous’or ‘jumpy’
sound of fast processing. The secondary Compressor
is set further away from the Target as to allow more
transients. The goal of this preset is to achieve a
consistent output while preserving some of the original
dynamics of the input signal.
AGGRESSIVE PRESET – The Aggressive preset has
1:1 Ratios and short Attack / Release times. The
secondary Compressor is set close to the target to
reduce transients. Frequency compensation has been
turned off to allow equal spectral gain to be applied to
the lowest of input signals. The goal of this preset is to
achieve very consistent outputs with limited dynamic
range.
Programming Menu
To enter the programming menu press the ENTER key from the home screen while NLC5.1ST is
unlocked. The ENTER key will enter the selected sub menu or enter the value selection mode for the
selected option. A press of the BACK key will navigate to the previous menu level or will revert the
current value to its last stored state.
Parameter Default
Correction Ratio 1.00
Upper Threshold 0 dB
Lower Threshold 0 dB
Dead Band 1.0 dB
Noise Floor -50.0 LKFS
Attack/Rise 15 ms
Release/Fall 60 ms
Frequency Shaping 0
Compressor Threshold 3.0 dB
Compressor Ration 0.8 dB
NLC Measure NLM
5.1 Target Level -24 dB
ST Target Level -24 dB
Parameter Default
Correction Ratio 0.80
Upper Threshold 0 dB
Lower Threshold 0 dB
Dead Band 6.0 dB
Noise Floor -50.0 LKFS
Attack/Rise 50 ms
Release/Fall 220 ms
Frequency Shaping 0
Compressor Threshold 5.0 dB
Compressor Ration 0.5 dB
NLC Measure NLM
5.1 Target Level -24 dB
ST Target Level -24 dB
Root Programming Menu Screen