DaySequerra NLC5.1ST User Manual

Page 23

NLC5.1ST User Manual

Clock Source: Defines where NLC5.1ST gets the timing signal to sync its internal clock.

 1/2: Processing with be synchronized with the clock recovered from the AES 1/2 Input. (Default

Setting)



3/4: Processing with be synchronized with the clock recovered from the AES 3/4 Input.



5/6: Processing with be synchronized with the clock recovered from the AES 5/6 Input.



ST: Processing with be synchronized with the clock recovered from the AES 7/8 Input.



Internal: Processing with be synchronized with the NLC5.1ST internal clock.

 External: Processing with be synchronized with the clock recovered from the External AES Sync

Input.

Sample Rate: If Clock Source is set to internal, defines what sample rate frequency NLC5.1ST will use.
(32.0, 44.1, 48.0, 88.2 or 96.0 kHz) Otherwise, the detected sample rate recovered from the configured
clock source is shown.

Audio Input Menu

NOTE: Unless your NLC5.1ST has the factory-installed HD/SDI I/O module installed, your screen will
differ from that above.

Audio Source: Determines which set of physical inputs NLC5.1ST will use to receive audio. Only the
installed options will be available; only one input type may be used at a time:

AES Inputs: Audio input is from the BNC AES input jacks. (Default Setting)

HD/SDI Inputs 1-8: Audio input is from the HD/SDI input jack, embedded audio channels 1-8.

HD/SDI Mapping: Enters the HD/SDI mapping sub-menu to assign a custom channel configuration.
Will only be present if the HD/SDI I/O module is installed.