Bonaire Ducted RAC Inverter - Manual (Page 4)

Page 4
INTRODUCTION
INTRODUCTI ON
Congratulations on purchasing this Bonaire Ducted Inverter Reverse Cycle Air Conditioning system, an
exciting new product offered by Climate Technologies.
Bonaire Ducted Inverter Reverse Cycle Air Conditioners are designed and constructed for the harsh
Australian climate offering unsurpassed efficiency and durability.
Your air conditioning unit is supported by Climate Technologies, Australia’s most advanced manufacturer
of a complete range of climate control products.
To ensure you fully enjoy the benefits of this Ducted Inverter Reverse Cycle Air Conditioning system,
please read these instructions carefully and keep them handy for future reference.
If operated and maintained in accordance with this manual, this unit will provide you with years of comfort
and reliability. Please take the time to read this manual.
NOTE: As a responsible corporate citizen the manufacturer, being Climate Technologies, respects
the OHS&W laws of this country and abides by them. In doing so, our service providers reserve the
right to refuse service unless safety and accessibility to the unit can be guaranteed in accordance
with the installation instructions, State OH&S Policies and Australian Standards. The cost of any
extra equipment required to provide access to the unit for servicing is the responsibility of the
owner.
General Information
Important Notices
•
If an appropriately qualified and licensed person is not used to install the equipment or if it's not
installed according to the installation instructions along with State & Federal requirements, then Climate
Technologies will not accept responsibility for any problems, which occur as a result.
•
This manual should be considered as a permanent part of the air conditioning equipment and should
remain with this equipment. It should be read and understood by any persons that will be operating the
system.
NOTE: This operation manual must be carefully read before operating the air conditioner. If further
information or details and data are required, please contact your Bonaire dealer.
•
Climate Technologies pursues a policy of continual improvement in design and performance of its
products. The right is therefore reserved to vary specification without notice.
•
Climate Technologies cannot anticipate every possible circumstance that might involve a potential
hazard.
•
This air conditioner is designed for standard air conditioning use only. Do not use this air conditioner
for other purposes such as drying clothes, refrigerating foods or for any other similar heating or cooling
processes.
Warranty
Warranty service work must only be carried out by Climate Technologies service division or its authorized
service providers. See warranty section.
Data Location
Your appliance model number, serial number and model description are located on the appliance data
plate on the side of both the indoor and outdoor units. These details should also be recorded in the
warranty section of this booklet.
You will need this information, should your appliance require servicing, spare parts or just if you require
additional information about this product.