Avalue ECM-LX800D - Manual (Page 44)

ECM-LX800D
44 ECM-LX800D User ’s Manual
3.5.2.4 First/Second/Third/Other Boot Device
The BIOS attempts to load the operating system from the devices in the sequence selected
in these items.
Item Description
LS120 LS120 Device
HDD-0 Hard Disk Device 0
SCSI SCSI Device
CDROM CDROM Device
HDD-1 Hard Disk Device 1
USB-FDD USB Floppy Device
USB-ZIP USB ZIP Device
USB-CDROM USB CDROM Device
USB-HDD USB Hard Disk Device
LAN Network Device
Disabled Disabled any boot device
3.5.2.5 Boot Up NumLock Status
Select power on state for NumLock.
Item Description
Enabled Enable NumLock
Disabled Disable NumLock
3.5.2.6 Gate A20 Option
Select if chipset or keyboard controller should control Gate A20.
Item Description
Normal A pin in the keyboard controller controls Gate A20
Fast Lets chipset control Gate A20
3.5.2.7 Typematic Rate Setting
Key strokes repeat at a rate determined by the keyboard controller. When enabled, the
typematic rate and typematic delay can be selected.
Item Description
Enabled Enable typematic rate/delay setting
Disabled Disable typematic rate/delay setting
3.5.2.8 Typematic Rate (Chars/Sec)
Select
“Enabled” of Typematic Rate then set the rate at which a character keeps repeating
while holding down a key.
The choices: 6,8,10,12,15,20,24,30
3.5.2.9 Typematic Delay (Msec)
Select
“Enabled” of Typematic Rate then set the length of delay before keying strokes to
repeat.
The choices: 250, 500, 750, 1000
3.5.2.10 Security Option
To allow selecting whether the password is required every time the system boots or only
when you enter the Setup.
Item Description
Setup Require password when entering the main CMOS Setup Utility Screen only.
System Require password every time the system boots