ADLINK MXC-6000 Series - Manual (Page 36)

24 Introduction
1.6.12 eSATA connector
The MXC-6000 controller provides one eSATA port connector on
the front panel. The MXC-6000 series supports external SATA
storage expansion, although the connector supports only the
SATA signal, whereby the SATA HDD requires connection to
external DC power to function.
1.6.13 DC Power connector
The DC power supply connector of the MXC-6000 series controller
is on the front panel. The power supply connector consists of three
pins, V+, chassis ground, and V- from right to left respectively. V+
and V- pins provide DC power input and the chassis ground pin
allows connection of the chassis to ground for better EMC compat-
ibility. The DC power input for the MXC-6000 series controller
allows a voltage input range from 9 V DC to 32 V DC.
NOTE: NOTE:
Keyboard & mouse PS/2 connectors do not support hot-
plug capability.
WARNING:
Ensure that the DC power supply:
X is within the input voltage range defined in the
specification
X is stable and low-noise DC
X provides sufficient operating current
DC power supply over or under voltage, unstable, or of insuffi-
cient power may cause system instability and physical damage