ADLINK cPCI-3510 Series - Manual (Page 121)

BIOS Setup Utility 107
cPCI-3510
Stop Bits
Stop bits indicate the end of a serial data packet. (A start bit
indicates the beginning). The standard setting is 1 stop bit.
Communication with slow devices may require more than 1
stop bit. Set this value to 1 and 2.
Flow Control
Set this option to select Flow Control for console redirection.
The settings for this value are None, Hardware RTS/CTS.
VT-UTF8 Combo Key Support
Enables VT-UTF8 combination key support for ANSI/VT100
terminals.Set this value to Enabled/Disabled.
Recorder Mode
When this mode is enabled, only text will be sent. This is to
capture terminal data. Set this value to Enabled/Disabled.
Resolution 100x31
Set this option to extended terminal resolution. Set this value to
Enabled/Disabled.
Legacy OS Redirection
On legacy OS, the number of rows and columns supported for
redirection. Set this value to 80x24, 80x25.
Putty Key Pad
Select FunctionKey and KeyPad on Putty. Set this value to
VT100, LINUX, XTERMR6, SCO, ESCN, VT400.