ADLINK aTCA-N700 - Manual (Page 13)

Switch Manager Configuration Guide
13
Example
Show all available commands on this mode.
4.2.2 Exit Current Mode
The following command allows you to exit the current mode.
Command description
exit Exit current mode and return to the previous mode
Example
Exit current mode and return to the previous mode.
ATCA-N700# exit
ATCA-N700>
ATCA-N700# ?
acl ACL
clear Clear functions
diag Enter into diagnostic mode
exit Exit current mode and down to previous mode
ip IP information
l2 Layer-2 subsystem
list Print command list
no Negate a command or set its defaults
password Assign the privileged level password
ping send count echo messages
port Port subsystem
restore Reset start-up configuration to factory default. Never try unless you know the
meaning!
route route
show how running system information
trunk Trunk group setting
vlan VLAN subsystem
write Write running configuration to start-up configuration file